Crankshaft sensor connectors
item condition : NEW
A 3-pin electrical pigtail connector specifically
designed for Nissan Crankshaft Position Sensors. It delivers precise signal transmission from the sensor to the Engine Control Unit (ECU). Manufactured from high-grade, heat-resistant plastic (PBT/PA66) to withstand extreme engine bay temperatures. Equipped with weatherproof weather-pack rubber seals to prevent moisture and dust ingress, eliminating corrosion risks. Features high-conductivity copper wiring with premium insulation to prevent signal loss, engine misfires, or sudden stalling
Direct Replacement: Comes with pre-stripped pigtail wires for easy soldering or crimping, avoiding full harness replacement.
Diagnostic Note: Damaged connector latches or loose pins often trigger fault code P0335 and cause long-crank or no-start conditions.
Workshop Tip: Always solder the wire joints and apply heat-shrink tubing to prevent resistance drops and corrosion over time
⚠️ Compatibility Note: Wire colors on the connector may vary depending on the production line and may not always match the photos or your vehicle's original wiring harness. Please rest assured this difference is strictly cosmetic and does not affect product quality, compatibility, or proper installation.
